Juniper Networks Certified Specialist Enterprise Routing and Switching (JNCIS-ENT) JN0-347 Exam Questions with VCE and PDF for Free Download from PassLeader (Question 91 – Question 100)

The newest Juniper JN0-347 dumps are available from PassLeader, you can get both JN0-347 VCE dumps and JN0-347 PDF dumps from PassLeader! PassLeader have added the newest JN0-347 exam questions into its JN0-347 VCE and PDF dumps now, the new JN0-347 braindumps will help you 100% passing the JNCIS-ENT JN0-347 exam. Welcome to download the valid PassLeader JN0-347 dumps VCE and PDF here: https://www.passleader.com/jn0-347.html (140 Q&As Dumps)

Besides, download that PassLeader JN0-347 braindumps from Google Drive: https://drive.google.com/open?id=0B-ob6L_QjGLpYUVOTktxMmFWLUU (FREE VERSION!!!)

QUESTION 91
Which two values are used to generate a bridge ID when using STP? (Choose two.)

A.    system MAC address
B.    bridge priority
C.    port identifier
D.    loopback IP address

Answer: AB

QUESTION 92
Referring to the exhibit, when using the default routing behavior, what happens to Packet A and Packet B on R1?
passleader-JN0-347-dumps-921

A.    Packet A is rejected and Packet B is forwarded to its destination.
B.    Packet A is forwarded to its destination and Packet B is rejected.
C.    Packet A and Packet B are forwarded to their respective destinations.
D.    Packet A and Packet B are discarded.

Answer: B

QUESTION 93
Which statement is true about GRE tunnels?

A.    GRE tunnels can be used for only IPpackets.
B.    GRE tunnels ensure that a packet does not live forever.
C.    Packets are encapsulated unchanged before entering the tunnel.
D.    GRE tunnels support point-to-multipoint.

Answer: C

QUESTION 94
What are three types of bridge protocol data units? (Choose three.)

A.    media endpoint discovery
B.    topology change acknowledgement
C.    topology change notification
D.    type length value
E.    configuration

Answer: BCE

QUESTION 95
A routing table contains multiple BGP routes to the same destination prefix. The route preference is the same for each route.
passleader-JN0-347-dumps-951
Referring to the exhibit, which route would be selected?

A.    Route B
B.    Route D
C.    Route A
D.    Route C

Answer: B

QUESTION 96
Which area is reserved for the OSPF backbone?

A.    Area 0.0.0.0
B.    Area 1.1.1.1
C.    Area 2.2.2.2
D.    Area 3.3.3.3

Answer: A

QUESTION 97
You are performing network tests and notice that the Layer 3 interface in the Finance VLAN on an EX Series switch is not responding to pings. You review the device status from the console. What is causing the problem, as shown in the exhibit?
passleader-JN0-347-dumps-971

A.    There are no active physical ports in the Finance VLAN.
B.    There is no route in the routing table for the Finance VLAN Layer 3 interface.
C.    The Layer 3 interface in the Finance VLAN is administratively disabled.
D.    There are no interfaces configured in the Finance VLAN.

Answer: B

QUESTION 98
The configuration shown in the exhibit was committed on an EX Series switch. You are notified that the phone using the voice VLAN does not work. You determine that voice traffic is not passing through the local switch.
passleader-JN0-347-dumps-981
What should be done to solve the problem?

A.    You should add the voice VLAN as a member on the ge-0/0/8.0 interface.
B.    You should change the port mode on ge-0/0/9.0 totrunk.
C.    You should add the voice VLAN as a member on the ge-0/0/9.0 interface.
D.    You should change the voice VLAN ID to match the data VLAN ID.

Answer: A

QUESTION 99
You are unable to establish a BGP session between R2 and ISP-B.
passleader-JN0-347-dumps-991
Referring to the exhibit, what must be changed in the configuration?

A.    A local address statement with the lo0 address must be added to R2 undergroup external-a.
B.    An import policy statement must be added to R2 undergroup external-a to allow ISP-B to peer.
C.    The type external statement must be added to R2 undergroup external-b.
D.    The peer-as statement needs the AS number for ISP-B.

Answer: D

QUESTION 100
Referring to the outputs shown in the exhibit, which statement is correct?
passleader-JN0-347-dumps-1001

A.    The switch is the only switch in the RSTP topology.
B.    The switch’s bridge priority is 4k.
C.    The switch’s bridge priority is 16k.
D.    The switch is not the root bridge.

Answer: D


Thanks for reading the newest JN0-347 exam dumps! We recommend you to try the PREMIUM PassLeader JN0-347 dumps in VCE and PDF here: https://www.passleader.com/jn0-347.html (140 Q&As Dumps)

Also, you can download that PassLeader JN0-347 braindumps from Google Drive: https://drive.google.com/open?id=0B-ob6L_QjGLpYUVOTktxMmFWLUU (FREE VERSION!!!)