The newest Juniper JN0-363 dumps are available from PassLeader, you can get both JN0-363 VCE dumps and JN0-363 PDF dumps from PassLeader! PassLeader have added the newest JN0-363 exam questions into its JN0-363 VCE and PDF dumps now, the new JN0-363 braindumps will help you 100% passing the JNCIS-SP JN0-363 exam. Welcome to download the valid PassLeader JN0-363 dumps VCE and PDF here: https://www.passleader.com/jn0-363.html (293 Q&As Dumps)
Besides, download that PassLeader JN0-363 braindumps from Google Drive: https://drive.google.com/drive/folders/1-A1yRzN9Nc4dyCRB0RnDiAdkfO5r9RUS (~More JN0-363 Exam Questions in PDF file~)
NEW QUESTION 241
What are two types of SlDs used in segment touting? (Choose two.)
A. node
B. adjacency
C. link
D. interface
Answer: AB
NEW QUESTION 242
What is a key differentiators of generate routes from aggregate routes?
A. Generate routes use a forwarding next hop.
B. Generate routes have a default next-hop value of reject.
C. Generate routes have a default preference value of 210.
D. Generate routes cannot be used as a gateway of last resort.
Answer: C
NEW QUESTION 243
You are asked to create connections between routing instances on the same Junos device and route between the connected Instances. What are two ways to accomplish this task? (Choose two.)
A. Use physical interfaces.
B. Use an IRB interface.
C. Use logical tunnel interfaces.
D. Use loopback interfaces.
Answer: AB
NEW QUESTION 244
What are three well-known mandatory BGP attributes? (Choose three.)
A. next hop
B. origin
C. community
D. MED
E. AS path
Answer: ABE
NEW QUESTION 245
What are two bridging concepts that are used to maintain an Ethernet switching table? (Choose two.)
A. learning
B. exporting
C. aging
D. timing
Answer: AC
Explanation:
https://www.juniper.net/documentation/us/en/software/junos/multicast-l2/topics/topic-map/bridging-and-vlans.html
NEW QUESTION 246
Which two statements ate correct about the community BGP attribute on a Junos device? (Choose two.)
A. The community attribute is a mandatory BGP attribute.
B. If the community attribute is present, it is ignored and deleted in the BGP updates.
C. If the community attribute is present, it should be passed unchanged in the BGP updates.
D. The community attribute is an optional BGP attribute.
Answer: AC
NEW QUESTION 247
You are asked to configure an LSP which uses the OSPF link state database for path computations. Which two statements are correct in this scenario? (Choose two.)
A. You must use the no-cspf parameter in the label-switched-path configuration.
B. Traffic engineering extensions ate enabled by default in OSPF.
C. Traffic engineering extensions are not enabled by default in OSPF.
D. You must use the policing parameter in the label-switched-path configuration.
Answer: AC
NEW QUESTION 248
The segment touting SRGB start label is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)
A. The first usable label is 10,001.
B. The last usable label is 10.501.
C. The last usable label is 10,499.
D. The first usable label is 10,000.
Answer: CD
NEW QUESTION 249
An OSPF router does not have a router ID configured. In this scenario, which statement is correct about the router ID?
A. The Junos OS will use the IP address assigned to the interface with the lowest MAC address.
B. A router ID will not be assigned until it is manually configured.
C. The Junos OS will use the IP address assigned to the loopback interface for the router ID.
D. The Junos OS will use the IP address assigned to the Interface with the highest priority.
Answer: B
NEW QUESTION 250
What are three types of MPLS routers? (Choose three.)
A. transit routers
B. peering routers
C. egress routers
D. aggregation routers
E. ingress routers
Answer: ACE
NEW QUESTION 251
You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy this requirement? (Choose two.)
A. GRES
B. VRRP
C. NSR
D. ISSU
Answer: BC
NEW QUESTION 252
Which BGP attribute Is used to detect touting loops?
A. AS path
B. MED
C. local preference
D. next hop
Answer: A
NEW QUESTION 253
Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)
A. A route learned by EBGP will be re-advertised to IBGP peers.
B. A route learned by IBGP will not be re-advertised lo IBGP peers.
C. A route learned by EBGP will not be re-advertised to IBGP peers.
D. A route learned by IBGP will be re-advertised to IBGP peers.
Answer: CD
NEW QUESTION 254
Which two LSA types are permuted in OSPF totally stubby areas? (Choose two.)
A. Type 1
B. Type 3
C. Type 5
D. Type 7
Answer: CD
NEW QUESTION 255
Which LSA type does an OSPF ABR use to advertise external routes generated by an NSSAASBR into the backbone?
A. Type 5
B. Type 7
C. Type 3
D. Type 1
Answer: C
NEW QUESTION 256
Which two statements are correct when using LDP? (Choose two.)
A. The inet.3 table will contain only the paths explicitly defined.
B. The inet.3 table will contain a full mesh of label-switched paths to other LDP-enabled routers.
C. LDP label-switched paths are created by configuring LDP on at least one physical router interface.
D. LDP label-switched paths are created by configuring LDP on the Loopback Interface.
Answer: BC
NEW QUESTION 257
Which two interface types are used as tunnel endpoints? (Choose two.)
A. ae
B. ip
C. ge
D. gr
Answer: BC
NEW QUESTION 258
How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?
A. The device sends out a network broadcast message asking for all devices and MAC addresses on the network and stores this information in addition to the interface from which the response was received.
B. The device learns the destination MAC addresses from traffic in the network and stores this MAC address in addition to the interface from which the traffic was received.
C. The device learns the source MAC addresses from traffic in the network and stores this MAC address in addition to the interface from which the traffic was received.
D. The device sends out a network multicast message asking for all devices and MAC addresses on the network and stores this information in addition to the interface from which the response was received.
Answer: D
NEW QUESTION 259
Which two statements are correct about the BGP next-hop attribute value? (Choose two.)
A. By default, the next-hop value is changed across iBGP links.
B. By default, the next-hop value is changed across eBGP links.
C. By default, the next-hop value is not changed across iBGP links.
D. By default, the next-hop value is not changed across eBGP links.
Answer: AD
NEW QUESTION 260
You are bringing a new network online with three IS-IS routers using default Junos election priorities. The routers are configured as Level 2 only IS-IS routers. Which statement is true about the DIS election in this scenario?
A. The router with the highest MAC address will be elected as the DIS.
B. The router with the highest numerical lo0 IP address will be elected as the DIS.
C. The router with the lowest numerical lo0 IP address will be elected as the DIS.
D. The router with the lowest MAC address will be elected as the DIS.
Answer: B
NEW QUESTION 261
……
Thanks for reading the newest JN0-363 exam dumps! We recommend you to try the PREMIUM PassLeader JN0-363 dumps in VCE and PDF here: https://www.passleader.com/jn0-363.html (293 Q&As Dumps)
Also, you can download that PassLeader JN0-363 braindumps from Google Drive: https://drive.google.com/drive/folders/1-A1yRzN9Nc4dyCRB0RnDiAdkfO5r9RUS (~More JN0-363 Exam Questions in PDF file~)